Cobra SPYBALL 6829 User Instructions page 20

If the full system is armed:
Turn ignition on.  The alarm starts to sound.
1.
Wait.  The alarm stops. The LED switches off, then it starts to flash slowly.
2.
3. Count the number of flashes. As soon as the number of flashes equals the first number of
your PIN code, turn the ignition off (for example, if the first number of your code is 3, then
wait for the LED to flash 3 times before turning the ignition OFF).  The LED switches
off.
4. Within three seconds, turn the ignition on again. Count the number of flashes. As soon as
the number of flashes equals the second number of your PIN code, turn the ignition off
(for example, if the second number of your code is 10, then wait for the LED to flash ten
times before turning the ignition OFF).  The LED switches off.
Enter the remaining numbers of the PIN code using the same procedure.  In the event
5.
of an error, an alarm cycle will follow. At the end of the alarm cycle you will be able to
repeat the procedure.
ONCE ALL THE DIGITS HAVE BEEN ENTERED CORRECTLY, THE SYSTEM DISARMS
WITH A LONG BLEEP AND THEN SWITCHES TO SERVICE MODE (see paragraph 12).
If only the immobiliser is armed (Spyball 6829):
1. Turn ignition on.
Wait.  The LED switches off, then it starts to flash slowly.
2.
Enter the digits of the PIN code using the same procedure as described above.  In the
3.
event of an error entering the first two digits, the LED will start to flash quickly. Turn the
ignition on and repeat the procedure.
20

The LED flashes quickly for 12 secs.