Biker Recognition Function; Selection Of The Biker Recognition Function - Cobra SPYBALL 6829 User Instructions

3. BIKER RECOGNITION FUNCTION

Besides its operation as a conventional remote control key, the transmitter can be used in
Biker Recognition mode.This function is selectable.
When the Biker Recognition function is enabled, the transmitter sends a coded signal at
regular intervals (1.5 secs). The small LED on the transmitter flashes at the same rate. In this
configuration the full security system (6829 = immobiliser + alarm, 6809 = alarm) activates
automatically as the transmitter goes beyond the range of the receiver, i.e when the biker
walks more than approximately 3 metres away from the parked motorcycle with the transmitter
in his/her pocket. Similarly, it deactivates when the biker returns to his/her vehicle and the
transmitter signal reaches the receiver. For more details regarding arming and disarming in
Biker Recognition mode, please see also the information provided in the paragraphs below.

3.1. Selection of the Biker Recognition function

This selection needs to be made on both the control unit and the transmitter.
For the setting of the control unit, please refer to the chart included in paragraph 14, which
provides general information about the possible configurations of the system (5 selectable
functions).
Additionally, the Biker Recognition function needs to be activated/deactivated via the
transmitter:
To activate, press and hold down both push-buttons at the same time until the small LED
located on the transmitter starts to flash quickly for about 2 seconds. (*)
To deactivate, press and hold down both buttons until you get a long flash from the LED (*).
6