Table of Contents
Advertisement
How to program the Airlab
14 HOW TO PROGRAM THE AIRLAB
As you might have noticed the Airlab has a LCD in the center
section of the master panel with a number of switches
positioned below that display.
If you turn on the Airlab you'll notice the following text in the
display.
This is the menu that's normally active. But before we go
into this menu we need to program the Airlab conform to your requirements. This can be done without
opening the frame. Very convenient, isn't it?
BEFORE YOU START TAKE NOTICE OF THE FOLLOWING INFORMATION
To save all the work you've done you simply hit the ENTER switch and all settings are stored in the
internal memory of the Airlab. If you leave the modules set-up section with the ESC switch, all
previously stored data (before you changed it) will still be active.
MAIN MENUS
To leave the timer menu you have to press the UP or DOWN switches in the center of the programming
area. If you do this you'll notice the following four main menus.
The sequence of these main menus can be different whether you hit the UP or DOWN button, but it will
never be more than these four activities.
The Module settings for the Triple Line Module and de Triple Dig Module are the same and therefore you
don't see a difference between the two models in programming.
14.1 MODULE SETTINGS
LINE A ENABLES START TIMER
To see what's under these names you hit the ENTER switch.
Lets go to MODULE SETTINGS first and then hit ENTER.
The following display on the right will be shown:
This option allows you to select one or more modules, which
need to be able to activate the internal TIMER when in Line A
input position.
HOW TO PROGRAM
The SELECT switches in the modules have a dual function. They select the module you are
programming and at the same time you can toggle between starting the timer (LED on) and not starting
the timer (LED off) in that module. This is a very quick way of programming.
If you have already programmed several modules, the moment you enter this menu the LED's located
near the SELECT switch will light up on those modules that are programmed to start the TIMER (when
the fader is up or the ON switch is activated).
Airlab from D&R Phone +31 294 418014, email:
TIMER (default)
MODULE SETTINGS
MASTER SETTINGS
SYSTEM
LineA Timerstrt?
Toggle by SELECT
info@d-r.nl
00:00:00
TIMER
Page 48
Hide quick links:
Advertisement
Table of Contents
