D&R Airlab User Manual page 17

Triple Dig Input Module
PAN
Allows adjustment between the left and right channel outputs.
CUE/SELECT
Stereo pre-fade listening; allows pre-fade listening of the channel with the fader closed.
The CUE function will be automatically TURNED OFF when the channel becomes active.
The CUE switch also generates a start/stop pulse in the line-mode.
The CUE switch also acts as a SELECT switch for the programming of the modules
functions.
ON
Channel on/off switch. The Airlab is capable of sending out a pulse by ON switch as well as
by fader. This is software programmable. In any case the adjacent LED will lit when the ON
switch is activated.
FADER
The linear fader controls a VCA that controls the module's overall level. Electronics sense
when the fader is opened and generates (when programmed) the start for remotely
connected devices.
Digital Output
The Digital output is the PROG-bus or the SUB-bus by Jumper selectable. The output
level (digital headroom) can be trimmed by the internal level trimmers
12).
The audio signal on the AES3-out and S/P-dif-out are the same.
Airlab from D&R Phone +31 294 418014, email: info@d-r.nl
(see also chapter
Page 17