Energy Save Operation - Fujitsu ART36AL(3)H Operating Manual

Duct type
Table of Contents

Advertisement

To confirm or Change Settings
Before Starting Operation
G To confirm settings
Press the TIMER MODE button once.
(The timer setting information will be
displayed for 15 seconds after the
TIMER MODE button is pressed.)
G To change settings
Confirm the settings as noted above,
then press the SET TIME button and
TIMER MODE button as necessary to
change the desired timer setting.
(The timer settings will be displayed
for 15 seconds after the button is
pressed.)
G After confirming or changing the set-
tings, press the START/STOP button
to start operation.

ENERGY SAVE OPERATION

Instructions relating to heating(*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
To Use the ENERGY SAVE
Press the ENERGY SAVE button.
The unit will run in the ENERGY SAVE mode.
To Stop the ENERGY SAVE
Press the ENERGY SAVE button one more time.
The ENERGY SAVE mode will be turned off.
The ENERGY SAVE light goes off, and the unit will return to the former operat-
ing conditions.
About the ENERGY SAVE
G The energy conservation mode (ENERGY SAVE) raises the set temperature slightly in the cooling mode and lowers the set
temperature in the heating mode, using a computer program to economically control the operation of the unit.
G If you press the ENERGY SAVE button while the air conditioner is on, it will change to the conservation mode. If you press
the ENERGY SAVE button while the unit is in the timer mode (ON timer, PROGRAM timer, or REPEAT timer), the unit will go
into the conservation mode when the unit starts with the timer.
G If you turn off the air conditioner while in the conservation mode, the mode will be shut off.
G The temperature set on the remote controller will not change if the energy save mode is used.
I *When Heating
After the ENERGY SAVE button is pressed, the set tempera-
ture will be lowered about 1°C every 30 minutes. When it
has lowered a total of 2°C, then it will hold that tempera-
ture.
1°C
30 min.
L Set to the ENERGY SAVE mode.
To Change the Timer Setting
During Operation
G OFF Timer / ON Timer
Press the SET TIME button and set
the timer time.
G PROGRAM Timer / REPEAT Timer
1. Follow the instructions given in the
section "OFF Timer/ON Timer" to dis-
play the timer setting you wish to
change.
2. Press the TIMER MODE button to dis-
play either "OFF → ON" or "OFF ←
ON".
To Change the Timer Mode
During Operation
Press the TIMER MODE button and set
the unit to the desired mode.
2°C
To Cancel the Timer Mode
During Timer Operation
Press the TIMER MODE button and set
the display to "NON STOP" (the unit will
switch to non-stop operation).
To Stop Operation During
Use of Timer Mode
Press the START/STOP button.
NON STOP
OFF ON
TIMER
PROGRAM
REPEAT
CLOCK ADJUST
I When Cooling
After the ENERGY SAVE button is pressed, the set tempera-
ture will be raised about 0.5°C every 30 minutes. When it
has gone up a total of 1°C, then it will hold that tempera-
ture.
M Set to the ENERGY SAVE mode.
30 min.
0.5°C
CLOCK
TEMP.
FAN AUTO
°
OFF
HEAT
FAN HIGH
ON
FAN
FAN MED
TIMER
COOL
FAN LOW
ON
OFF
TIMER
SET
SET
FAN
MODE
TIME
TEMP.
CONTROL
CONTROL
ENERGY
ZONE
SAVE
CONTROL
1°C
DEFROST
TEST
MASTER
START
STOP
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents