Energy Save Operation; Manual Auto Operation - Fujitsu ABT18RG Operating Manual

ENERGY SAVE OPERATION

Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
The air conditioner can be operated while keeping energy consumption costs down.
How To Use the ENERGY SAVE OPERATION
1
Press the START/STOP button
(if the unit is already operating, proceed to step 2).
The indoor unit's OPERATION indicator lamp (red) will light.
2 Press the MASTER CONTROL button to select the
COOL, DRY, *HEAT mode.
3 Press the ENERGY SAVE button.
ENERGY SAVE can only be used if the MASTER CONTROL button is used
to select the "COOL", "DRY" or *"HEAT".
About the ENERGY SAVE
The air conditioner saves energy costs by controlling the thermostat temperature setting.
*During Heating operation:
The thermostat temperature setting decreases by 1 °C as
soon as the ENERGY SAVE button is pressed, and then de-
creases by another 1 °C every thirty minutes.
Afterwards, energy consumption is saved by continuing to
heat at a thermostat temperature of 4 °C less than that set.
ENERGY SAVE setting
1 °C
2 °C
ENERGY
30 minutes
SAVE ON
1 hour
1 hour 30 minutes

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the remote control unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button on the main unit control
panel.
To stop operation, press the MANUAL AUTO button once again.
Set temperature
3 °C
4 °C
To Cancel the ENERGY SAVE:
Press the ENERGY SAVE button.
During Cooling/Dry operation:
The thermostat temperature setting increases by 1 °C as soon
as the ENERGY SAVE button is pressed, and then increases
by another 1 °C after one hour has passed.
Afterwards, energy consumption is saved by continuing to
cool or dry at a thermostat temperature of 2 °C more than
that set.
ENERGY SAVE setting
1 hour
ENERGY
SAVE ON
1 °C
G When the air conditioner is operated
G The fan speed selected will be "AUTO"
SET SWING
SET SWING
TIME TEST
ENERGY
ADJUST RUN ACL
SAVE
2 °C
Set temperature
with the controls on the Main unit, it
will operate under the same mode as
the AUTO mode selected on the re-
mote control unit (See page 8).
and the thermostat setting will be 23 ˚C.
13