Timer Operation - Fujitsu ART36AL(3)H Operating Manual

TIMER OPERATION

Press the START/STOP button; after the unit starts operation perform the following procedure:
OFF Timer / ON Timer
1
Press the TIMER MODE button and display either OFF
Timer or ON Timer.
The timer will start operating. (If you set the ON timer, the air conditioner
will stop operating).
Each time the button is pressed the timer function changes in the follow-
ing order:
RESET
c
REPEAT
d
2 Press the SET TIME button and set the timer time.
L : Use to advance the time forward.
M : Use to turn the time back.
(Press once to move the time 1 minute; hold down and the time will move
10 minutes at a time.)
PROGRAM Timer/REPEAT Timer
1 Setting the timer time.
Follow the instructions given in the section "OFF Timer / ON Timer" and
set the times for the ON timer and OFF timer modes.
2 Press the TIMER MODE button until the "PROGRAM"
or "REPEAT" mode display is shown.
About Timer Operation
PROGRAM Timer
G Combines the OFF timer and the ON timer for one
cycle.(OFF → ON, or OFF ← ON)
G Starts operation from the OFF timer or the ON timer,
whichever is closer to the current time.
8
OFF
c
PROGRAM(OFF → ON, OFF ← ON)
ON
c
d
REPEAT Timer
G Combines the operation of the OFF timer and the ON
timer (the cycle described in the PROGRAM timer above)
so they repeat the same cycle every day.
G Starts operation from the OFF timer or the ON timer,
whichever is closer to the current time.
CLOCK TEMP.
NON STOP FAN AUTO
°
OFF
OFF ON FAN HIGH
ON
TIMER FAN MED
TIMER
PROGRAM FAN LOW
ON
OFF
REPEAT
TIMER
SET SET FAN
MODE
TIME TEMP. CONTROL
CLOCK ADJUST
1
2
ENERGY ZONE
SAVE CONTROL
CLOCK TEMP.
NON STOP FAN AUTO
°
OFF
OFF ON FAN HIGH
ON
TIMER FAN MED
TIMER
PROGRAM FAN LOW
ON
OFF
REPEAT
Example: Setting the OFF TIMER
TIMER
to 23:35.
NON STOP CLOCK TEMP. FAN AUTO
°
OFF ON OFF FAN HIGH
ON
TIMER FAN MED
TIMER
PROGRAM FAN LOW
ON
OFF
REPEAT
TIMER
SET SET FAN
MODE
TIME TEMP. CONTROL
CLOCK ADJUST
2
ENERGY ZONE
SAVE CONTROL
Example:
If the OFF timer is set at 23:35 and the
ON timer at 6:00, and the unit is in the
PROGRAM timer mode. (Select the
REPEAT timer mode, "REPEAT" is
shown on the display.)
HEAT
FAN
COOL
DEFROST TEST
MASTER
CONTROL
START
STOP
HEAT
FAN
COOL
DEFROST TEST
HEAT
FAN
COOL
DEFROST TEST
MASTER
CONTROL
START
STOP