Pioneer DJM-900NXS Service Manual page 62

1
c Mode 12 : Device test. "DEVICE"
A
• Mode for displaying the device information for confirmation
When this mode is entered, "DEVICE" is displayed at the top of the FL display and the TAP button lights.
• Mode 12 consists of 4 pages for indicating the statuses of LAN, IP address, MAC address, and subnet mask.
The pages can be changed by pressing the BEAT c, d button.
• "OK" is displayed in the middle of the FL display when the device is operating properly, and "NG" is displayed when it is
not properly operating.
B
Check result
Device name
C
• You can also check the address data for a device.
The address data that can be confirmed are MAC address, IP address, and IP address, and they are indicated by 3 digits
at a time in the middle of the FL display.
If an address cannot be obtained, "EE" is displayed.
The address data pages can be changed with the AUTO/TAP or QUANTIZE button.
On the address data page, the current page No. and the total number of pages are displayed with lit segments at the
bottom of the FL display.
Note: With the QUANTIZE button, the pages can be changed cyclically, but with the AUTO/TAP button, the pages change
only in one direction (the page will not change if you press the key on Page 1).
Example: When the IP address is "169.254.238.238"
D
Address being
confirmed
Current page
E
Total number of pages
Devices and addresses that can be confirmed
Device, Address
LAN
LAN (MAC Address)
LAN (IP Address)
LAN (Subnet Mask)
*1 "EE" is also displayed while the IP address is being obtained. If "EE" is displayed for more than 15 seconds, something is wrong.
F
*2 "EE" is also displayed before the subnet mask data are obtained.
62
1
2
BEAT
d button
BEAT
c button
QUAN-
TIZE
button
AUTO
/TAP
button
FL Display Name
LAN
MCAdd
IPAd
Subn
DJM-900NXS
2
3
BEAT
d button
BEAT
c button
QUAN- QUAN-
TIZE TIZE
button button
AUTO AUTO
/TAP
button button
Remarks
Properly operating: OK, Not properly operating: NG
: Address value
Properly operating: Address value, Not properly operating: EE *1
Properly operating: Address value, Not properly operating: EE *2
3
4
BEAT
d button
BEAT
c button
/TAP
4