Kyocera TASKalfa 300i Service Manual page 151

Section Description
Optional 80
finisher Finisher timeout jam
(built-in finisher)
81
Paper entry sensor
nonarrival jam
82
Jam in stapler
83
Exit sensor stay jam
91
Finisher cover open
(document finisher)
92
Eject paper sensor
non-arrival jam (docu-
ment finisher)
Conditions
(Document finisher)
Paper ejection is not output from the machine to the doc-
ument finisher within specified time of the paper entry
sensor (PES) turning on.
(Built-in finisher)
Paper ejection is not output from the machine to the doc-
ument finisher within specified time of the paper convey-
ing switch (PCSW) turning on.
(Document finisher)
The paper entry sensor (PES) is not turned on even if a
specified time has elapsed after the machine eject signal
was received.
(Built-in finisher)
The paper conveying switch (PCSW) is not turned on
even if a specified time has elapsed after the machine
eject signal was received.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is con-
veyed to the process table from the paper conveying unit.
(Document finisher)
The staple home position sensor (STSPS) is not turned
on within the specified time when driving the staple motor
(STM).
(Built-in finisher)
The staple home position sensor (STHPS) is not turned
on within the specified time when driving the staple motor
(STM).
(Document finisher)
In the straight mode, the exit sensor (EPS) is not turned
off within specified time of its turning on.
(Document finisher)
In the bundle discharge mode or the staple mode, bundle
discharge operation does not turn off within specified time
since the operation starts.
(Built-in finisher)
The paper conveying switch (PCSW) does not turn off
within specified time of its turning on when paper is
ejected to the finisher tray from the process table.
The finisher cover becomes open during paper is run-
ning.
Paper is remaining in paths at power on.
In the straight mode, the eject paper sensor (EPS) is not
turned on even if a specified time has elapsed after the
paper entry sensor (PES) was turned on.
2K5-1
Specified time
15 s
15 s
1201 ms
2000 ms
1429 ms + Paper
length
-
600 ms
-
902 ms
1429 ms + Paper
length
-
-
1-4-7