Table of Contents
Advertisement
Precautions for use /
9
Declaration of compliance
Safety Instructions
Changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
To limit the risk of interference, people with pacemakers must keep the
wireless telephone away from their equipment ( minimum distance of 15 cm).
It is recommend to follow the standard acceptance procedures before using this
equipment in human safety critical areas ( hospitals...).
DECT equipment can only be used to establish links between fixed points if
these links are temporary and the equivalent isotropically radiated power at the
antenna is less than 250 mW.
The conditions of access to a DECT equipment telepoint network shall be
stipulated by contract with the operator of the authorized telepoint network
concerned.
Do not expose your telephone to severe conditions ( rain, sea air, dust, etc.).
You must not switch on or use your telephone near gas or inflammable liquids.
No guarantee is given concerning possible interference affecting DECT
equipment, due to other authorised utilisation of the radio frequencies
concerned.
The headset includes magnetic elements that may attract sharp metallic objects.
There is a danger of explosion if the battery is replaced incorrectly - user only
the battery with the reference 3GV28041AB ( 1.2V 1500 mAh) 3BN67202AA (
3.7V 650mAh).
Battery charge: Charge the battery for about 6 hours before initial use.
Regulatory Statements
EU/EFTA
This equipment is in compliance with the essential requirements of R&TTE
Directive 1999/5/EC.
The Declaration of Conformity may be obtained from your installer.
USA and Canada
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions: ( 1) this device may
not cause harmful interference, and ( 2) this device must accept any interference
received, including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules and ICES-003 of Canada. These
limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try correct the interference by consulting the dealer.
Exposure to Radio Frequency Signals.
This device has been designed and manufactured not to exceed the SAR ( Specific
Absorption Rate) radio frequency power transmission limits established by the
different countries concerned. The SAR value is 0.09 W/kg ( the globally accepted
maximum limit being 1.6 W/kg).
Other
33
Advertisement
Table of Contents
