Table of Contents
Advertisement
11
11.12
Repeating original image on one sheet: Image repeat
11.12.1
Setting repeat times automatically
Use the Size Manual Input mode to manually specify the scanning area of the original glass, then let the
machine to print the scanned image repeatedly on one sheet of copy paper.
Size Auto Detect mode will automatically detect the original size (image and surrounding blank area also),
then let the machine determine the number of repeats.
Mode
Size Manual Input
Size Auto Detect
0
Scan the original from original glass. The ADF cannot be used to scan the original.
0
Use the Size Manual Input mode to repeat a part of the original, not the entire image, by specifying the
scanning area.
0
Size Auto Detect mode uses Non-Image Area Erase to automatically detect the original size with the
ADF/original cover kept open.
1
Position original on the original glass.
–
When selecting Size Manual Input, place the original facedown on the original glass so that the
original image should fit within the area measured by vertical/horizontal width from the rear-left
corner. Close the ADF/original cover gently.
–
When selecting Size Auto Detect, open the ADF/original cover, then place the original facedown on
the original glass.
In this case, Non-Image Area Erase is automatically selected. Be sure to keep the ADF/original cover
open.
2
Touch [Application] on the Copy Screen.
3
Touch [Image Repeat] on the Application Screen.
11-34
Description
Horizontal width
Copy
Vertical
width
Copy
Application functions
CS655 Pro
Advertisement
Table of Contents
Troubleshooting
