Electra WNG 50 DCI Service Manual page 155

I N S T A L L A T I O N
FOR DCI SPLIT WALL MOUNTED AIR CONDITIONER
1
ACCESSORIES SUPPLIED WITH
THE AIR CONDITIONER
Shape Name
Mounting plate
Remote control
with batteries
Remote control
bracket
Screws
washer dowels
Screws dowels
Outdoor unit
drain connector
Mounting pads
Cable ties
Power input
cable
(Optional)
Cable terminals
Air purifying
filter
(Optional)
Remote control
operation
Unit operation
Installation manual
Indoor Unit's Accessories Only for One Unit.
Qty Used for
1 Wall mounting
of the indoor
unit
1 Operation of
unit
1 Wall mounting
of the remote
control
4
Wall mounting
of indoor unit
2 Wall mounting
of remote
control bracket
1 Outdoor unit
water drain
4 Padding of
outdoor unit
bottom support
4 Securing wires
in the indoor and
outdoor unit
1 Connecting indoor
unit power
1 Securing of
grounding wire
in the indoor
and outdoor unit
2
Cleaning the air
3 Users and
installers
reference
CONTENT
I N S T R U C T I O N S
2
LOCATION OF INDOOR AND
OUTDOOR UNIT
Select the location considering the following:
INDOOR UNIT
1. Choose a location which will provide good air
circulation.
2. Do not install the unit near a heat source or where it will
be exposed to direct sunlight.
3. The location must allow convenient electrical wiring.
drainage and tubing connections
4.The appliance must be positioned so that the plug is
accessible.
5 Installation site should provide an easy passage to
outdoors.
6. The unit must be mounted on a strong wall that will
withstand the generated vibrations.
7. Install the mounting plate as shown in
8. Install the remote control bracket as shown in fig 4.
OUTDOOR UNIT
1. The location must allow easy servicing and provide
good air circulation as shown in fig 5
2. The unit may be suspended from a wall by a bracket
(Optional) or located in a free standing position on the
floor (preferably slightly elevated).
3. If the unit is suspended, ensure that the bracket is
firmly connected and the wall is strong enough to
withstand vibrations.
4. Unit location should not disturb neighbors with noise or
exhaust air stream.
5. Place the mounting pads under the unit legs.
6. Refer to figure 5 for allowed installation distances.
7. When the unit is installed on a wall, install the drain
connector hose and drain plug as shown in
Fig.1
1.Bottom of outdoor unit
2.Drain connector
Fig. 1
2
as shown in fig 3 .
fig 5 .
.
fig 1 and fig 2 .
Fig.2
Drain installation
Example
Fig. 2