Table of Contents
Advertisement
❋
VARI
LITE VL3015LT S
Floor Mounting the Luminaire
The luminaire enclosure is sufficient to stabilize the
luminaire in a floor installation, provided that the
mounting surface is flat and sturdy.
WARNING: Light Beam Projects Intense Heat. Do not
illuminate objects within 4.0 m (13.2 feet) of the
VL3015LT Spot Luminaire. Objects within this range can
scorch, melt, or ignite from the heat projected by the light
beam.
Connecting Data and Power
A maximum of 32 luminaires may be connected in any one DMX data link.
Note: This maximum limit applies to the luminaire "daisy chain" only. Your system or console may
require fewer luminaires on a single data link path. Consult your console documentation for more
information.
To connect power and data:
Step 1. Connect data cable from console to first luminaire in chain at DATA IN connector.
Step 2. If required, connect additional data cables from DATA THRU connectors to DATA IN
connectors of remaining luminaires in link.
Step 3. At last luminaire in link, install a DMX termination connector at DATA THRU connector.
(Luminaires and other devices on the same DMX chain may not function properly without
termination.)
Step 4. Connect AC input cable connector to power input source.
Step 5. Dress AC input and data cables and secure them so that they will not interfere with
luminaire head and yoke movement.
(from console)
18
L
U
POT
UMINAIRE
SER
~
AC IN
DATA IN
DATA THRU
MENU
ENTER
Data Thru
Data In
Figure 2-7: Connecting Power and Data
'
M
S
ANUAL
~
AC IN
DATA IN
DATA THRU
MENU
ENTER
Data Thru
1 3 Dec emb er 2 012
Luminaire
Enclosure
Figure 2-6: Floor Mounting
~
AC IN
DATA IN
DATA THRU
MENU
ENTER
DMX Termination Connector
02 .9 698.00 02 0
Advertisement
Table of Contents
Troubleshooting
