Components; External Luminaire Components; Components External Luminaire Components - Philips VL3000 Service Manual

Components

External Luminaire Components

The following illustration shows the external luminaire components and controls.
Input Panel
Provides DMX In and Thru,
and AC Power connections.
(see detail below)
Input Panel Components
Product Label ID
Main Power
Switch
AC Input Cable
02.96 78.001 0 G
AC Input Cable
Backcap Assembly
Provides access to lamp
for replacement and
provides controls for
beam adjustment.
Yoke Assembly
Houses Master Control
Board (MCB).
AC PWR
~
DATA IN DATA THRU
AC IN
Data In
Data Thru
C : E
OMPONENTS XTERNAL
Upper Enclosure Assembly
Houses power supply, ballast,
and display board.
Head Assembly
Houses color, gobo, strobe, zoom lens
and/or beam spreader mechanisms
(dependant on luminaire model).
Menu Display
Used to input manual
commands, program, test,
set defaults and access
internal status information.
MENU ENTER
L C
UMINAIRE OMPONENTS
Truss Hook Bracket
Attaches to enclosure base
to allow truss hook installation.
Beam Adjustment Controls
CAUTION:
RISK OF FIRE. USE ONLY 1200 WATT, H TYPE 100V METAL HALIDE LAMP,
SFc10-4 BASE.
ATTENTION:
RISQUE D'INCENDIE. UTILISER UNIQUEMENT UNE LAMPA HALOGENE EN METAL DE
TYPE H, 1200 WATT, 100V ET UN SUPPORT SFc10-4.
CAUTION:
RISK OF EXPOSURE TO EXCESSIVE ULTRAVIOLET RADIATION. DO NOT OPERATE
WITHOUT COMPLETE LAMP ENCLOSURE IN PLACE OR WHEN LENS IS DAMAGED.
DISCONNECT FIXTURE
BEFORE RELAMPING
CAUTION: HOT LAMP
DO NOT OPEN FOR 5 MINUTES
AFTER SWITCHING OFF.
Y Z
1
X
5