Philips Vari-lite VL3015LT User Manual page 51

A timing value of zero is full speed. A time value of 100% (or DMX 255) enables the associated
parameter(s) to follow cue fade time (console time) rather than the timing channel.
Note: The particular storing syntax for your console, as well as instructions on how to write part cues,
can be found in the operation manual for that console.
To use these channels, you must:
Step 1. Create the cue, including color, gobo, edge and frost as required.
Step 2. Decide which fixtures and which parameter groups will use timing channels.
Step 3. Assign a value to the particular timing channel(s) you wish to use (for timing information,
see chart on next page).
Step 4. Set console timing (or cue fade time) for parameters and timing channels to zero seconds.
Step 5. Store cue.
Note: Avoid changing timing channel values in a fading cue. This can cause unexpected behavior in
the luminaire as the timing channel value is updated over time. Timing channel values and the final
destination of the parameters affected by the timing channel should always be sent in a zero count.
Timing channels can be set in either % or 0-255 (DMX) modes, with the following values assigned:
02.96 98.000 2 0
O : VL3015LT S
PERATION
Timing Channels Map
Table 3-13:
% Value DMX
0 0
1
2
1 3
4
2 5
6
7
3 8
9
4 10
11
12
5 13
14
6 15
16
17
7 18
19
1 3 Dec emb er 2 012
L T
POT UMINAIRE IMING
= Seconds
Full Speed
0.2
0.4
0.6
0.8
1
1.2
1.4
1.6
1.8
2
2.2
2.4
2.6
2.8
3
3.2
3.4
3.6
3.8
3
35