Luminaire Overview - Philips Vari-lite VL3015LT User Manual

Luminaire Overview

The following illustration shows the external luminaire components and controls.
Upper Enclosure Assembly
Houses power supply, ballast,
and display board.
Backcap Assembly
Provides access to lamp
for replacement and
provides controls for
beam adjustment.
Head Assembly
Houses CMY color, gobo,
strobe, prism, frost, zoom lens and iris
mechanisms.
Input Panel Components
Product Label ID
AC Input
02.96 98.000 2 0
Menu Display
Used to input manual
commands, program, test,
set defaults and access
internal status information.
~
AC IN DATA IN DATA THRU
MENU
Data In Data Thru
Figure 1-2: External Components and Controls
1 3 Dec emb er 2 012
D
ESCRIPTION
ENTER
: C
OMPONENTS
Mounting Brackets
Note: Truss hooks, clamps,
etc. are sold separately.
Input Panel
Provides DMX In and Thru,
and AC Power connections.
(see detail below)
Yoke Assembly
Houses Master Control
Board (MCB).
Beam Adjustment Controls
CAUTION:
RISK OF FIRE. USE ONLY 1500 WATT, H TYPE 100V METAL HALIDE LAMP,
SFc10-4 BASE.
ATTENTION:
RISQUE D'INCENDIE. UTILISER UNIQUEMENT UNE LAMPA HALOGENE EN METAL DE
TYPE H, 1500 WATT, 100V ET UN SUPPORT SFc10-4.
CAUTION:
RISK OF EXPOSURE TO EXCESSIVE ULTRAVIOLET RADIATION. DO NOT OPERATE
WITHOUT COMPLETE LAMP ENCLOSURE IN PLACE OR WHEN LENS IS DAMAGED.
DISCONNECT FIXTURE
BEFORE RELAMPING
CAUTION: HOT LAMP
DO NOT
OPEN FOR 5 MINUTES
AFTER SWITCHING OFF.
Y Z
1
X
7