Installation Procedures; Hanging The Luminaire - Philips Vari-lite VL3015LT User Manual

Installation Procedures

Hanging the Luminaire

The VL3015LT Spot Luminaire can be hung horizontally or vertically from any structure designed to
work with the type of load created by this moving luminaire. Two mounting bracket assemblies
(provided) are used to attach truss hooks or other mounting hardware as required. Many compatible
truss hooks are available from different manufacturers for your particular needs.
A minimum of one hook per truss hook bracket is required. If mounting method does not use truss
hooks, two attachment points per truss hook bracket are required. When attaching more than one point
on a single bracket, the attach points must be spaced as far apart as possible using the supplied
mounting holes.
Install mounting hardware and brackets:
Step 1. Install truss hooks on two provided truss hook brackets as required.
Truss Hook Hardware
(not provided)
Note: Various types of truss hooks can be used. The Mega Claw truss hook (as shown in the example
above) as well as many other standard hooks, can be ordered separately.
Step 2. Determine required configuration of bracket installation. Brackets may be installed in either
orientation as shown. The brackets must be parallel (as illustrated).
Step 3. While pulling up on locking mechanism release, fit keyed holes onto raised mounting
buttons at bottom of enclosure. Slide forward and release locking mechanism to lock in
place. Ensure brackets are locked securely. (Always face brackets in same direction as
shown.)
02.96 98.000 2 0
Bracket
Figure 2-2: Installing Truss Hooks
Bracket
Figure 2-3: Bracket Orientation Options
1 3 Dec emb er 2 012
I : I
NSTALLATION NSTALLATION
Mega Claw Truss Hook
(not provided)
2
P
ROCEDURES
Example Truss
Hook Installation
Bracket
15