Addressing; Program Starting Address; Program Starting Address Without Calibrating Luminaire - Philips Vari-lite VL3015LT User Manual

❋
VARI LITE VL3015LT S

Addressing

Program Starting Address

The address setting for DMX console controlled systems is entered using the Menu Display (refer to
"Menu Operation" on page
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
Program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to enter starting address.
Step 4. Press [Enter] to set.
Program Starting Address Without Calibrating
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display programming in
order to pre-program an address setting.

Program starting address without calibrating luminaire:

• While powering up luminaire, press and hold [Menu]. Program address as in
Address
• Press and hold [Menu] until display changes from "Starting" to the DMX address.
Note: The luminaire will require a reset to restore control. See
Functions" chapter on page 26
20
L U
POT UMINAIRE SER
46). The luminaire retains the DMX address even if power is removed.
above.
for control channel information on luminaire reset.
1 3 Dec emb er 2 012
' M
S ANUAL
Program Starting
"VL3015LT Spot Control Channel
02 .9 698.00 02 0