Philips Vari-lite VL3015LT User Manual page 33

Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows:
a. Connect one end of cable to luminaire handle.
b. Loop at least once around truss/pipe and attach other end of cable to other handle.
Step 4. Make sure service tilt and pan locks are disengaged so luminaire moves freely.
Step 5. Connect power and data cables according to procedure given in
Power" on page
SAFETY CABLE: Recommended for all hanging installation and may be required by national and local
codes. Use enclosure handles for safety cable anchor points for this fixture.
NOTE: The enclosure handles were tested and are in compliance (for safety cable anchor points) of
the following safety standards: IEC / EN 60598-2-17.6.6 and UL1573.
21.7 in /
551.2 mm
Top View
Safety Cable
(not included)
Loop at least
once on truss
through both
handles.
02.96 98.000 2 0
18.
40.7 in /
1033.8 mm
850.9 mm
Figure 2-5: Hanging Configuration and Dimensions
1 3 Dec emb er 2 012
I : I
NSTALLATION NSTALLATION
31.0 in /
788.0 mm
30.5 in /
774.7 mm
33.5 in /
Enclosure Handle
For complete luminaire dimensions refer to the
diagram under "Dimensions" on page
P
ROCEDURES
"Connecting Data and
IMPORTANT! Use only the inner
portion of the handle (as shown) to
anchor safety cable.
Inner Portion
71.
2
17