Table of Contents
Advertisement
USER GUIDE
INSTALLATION AND CONNECTION
Before putting the belt around your waist, clip the waistcoat clamps No. 18 on to the
edges of the waistcoat A and B.
Slip on the waistcoat straps, than the control box base No. 16 on to strap No.14 and,
once you have put the waistcoat on, adjust the abdominal straps Nos. 14 and 15 to suit
your size.
Connect socket No. 4 of the spiral cable to socket No. 5 on the ELECTRO'FLOR.
N.B. use the guide rod to make the correct connection.
Connect socket No. 17 to socket No. 3, place switch No.1 in the "On" position, then
press the trigger No. 10 only when you are about to start using the machine. The
ELECTRO'FLOR LED No. 7 should light up.
USING THE MACHINE
Press twice on trigger No. 10 every time you use the machine.
Control method:
1 – Short pressure on the trigger brings the machine into continuous operation. To
stop the machine, press briefly on the trigger once again.
2 – Sustained pressure on the trigger brings the machine into continuous operation
until you release the trigger.
Every time you disconnect and re-connect socket Nos. 4 and 5,
you MUST press
trigger No. 10 twice
to re-prime the safety system.
You can use wheel No. 20 to vary the brush rotation speed according to the fruit tree
varieties and the output you require.
When the ELECTRO'FLOR detects that the battery is discharged, LED No. 7 flashes
once every half-second, but the machine does not stop.
Stop work as soon as you feel a lack of power and put your battery on charge.
It will take at least 3 day's use to acquire a sound knowledge of how to operate
the machine.
Advertisement
Table of Contents
