Table of Contents
Advertisement
USING YOUR MACHINE FOR THE FIRST TIME
We strongly recommend that you ask for assistance from your retailer, who is authorised
to give you all the advice you need to use the machine properly and achieve a good
output.
He can guide you in your choice of the best brush to suit your needs and the different
types of fruit trees that you own.
Please read these instructions carefully before using the
Prepare the carbon shaft, half-shell and wires required, according to use.
Preparing a half-shell:
- Place a lock-nut on each half-shell (supplied with the machine (Picture 1)).
Picture 1
Assembling a unit:
1- Position the wire in the groove of a half-shell.
The wire must be positioned symmetrically.
2- Place the unit on the end of the carbon shaft (Picture 2).
3- Pinch the wire with a second half-shell.
4- Tighten the unit with the two screws supplied with the machine (Picture 3).
5- Repeat the procedure, with a different of 90° between each shell. Leave
approximately 3 cm of space free at the end for fixing the shaft to the chuck
(Picture 4).
Do not mount more than 8 wires per brush (max wire length 30 cm).
Picture 2
ASSEMBLING THE BRUSH
machine.
Advertisement
Table of Contents
