JVC RX-DP15BC Instructions Manual page 83

To use the stored signals
When you want to use the stored signals, follow the procedure
below.
IMPORTANT:
To operate the other component(s) using this remote control—
• Aim directly at the remote sensor(s) on the target component(s).
– This remote control can send signals at a distance of 7 m.
• You can also use the IR signal transmitter connected to this
receiver.
– Place the IR signal transmitter so that it is aimed at the remote
sensor(s) on the target component(s).
You can operate the other component(s) through the remote
sensor on this receiver.
When using the remote control:
– Set the ZONE 1/ZONE 2 (LEARN/TRANSMIT) selector to "ZONE 1" or
"ZONE 2" properly.
1. Set the LEARN/TRANSMIT (ZONE 1/ZONE 2)
selector to "TRANSMIT (ZONE 1/ZONE 2)."
LEARN TRANSMIT
ZONE 1 ZONE 2
For the Zone 1 operations
2. Press one of the source selecting buttons (or
CONTROL repeatedly) to select the desired
remote control operation mode (source).
DVD DVD MULTI PHONO
VCR 1 VCR 2 TAPE/MD
TV/DBS VIDEO FM/AM
3. Press the desired button.
TV/CATV/DBS
VCR 1
STANDBY/ON STANDBY/ON
TV VOL
EFFECT
1 2 3
LIVENESS
4 5 6
7 8 9
/P
10 0 + 10
100 +
RETURN
FM MODE
MENU
Notes:
• To operate the TV, CATV tuner, or DBS tuner, set the TV operation
mode selector correctly.
• To use the following buttons, you can skip step 2 above.
– TV/CATV/DBS (STANDBY/ON) , VCR 1
TV VOL +/–, TV/VIDEO, DVD MENU
• To use the following buttons, press DVD MENU first.
– SET, % / fi / @ / #
OR
LEARN TRANSMIT
ZONE 1 ZONE 2
For the Zone 2 operations
CD
CDR
EXT 7.1CH
/ REW PLAY FF/
DOWN TUNING UP
REC STOP PAUSE
TV/VIDEO
CHANNEL
SET
DVD
(STANDBY/ON) ,
To erase the stored signals
After erasing the stored signals, preset signals are resumed and you
can operate JVC's components again.
1. Set the LEARN/TRANSMIT (ZONE 1/
ZONE 2) selector to "LEARN."
2. Press and hold EXIT, then press one of the source
selecting buttons from which you want to erase
the stored signals.
EXIT
and
"CLEAR" appears on the display, and all the signals stored in
the selected remote mode (source) are erased at the same time.
Notes:
• You cannot erase a signal assigned to a particular button only.
Storing a new signal to a particular button erases the previously
stored signal.
• To erase the stored signals for "CD DISC," first press
CONTROL to select "CD DISC," then press CONTROL again
while holding EXIT this time.
\
3. Set the LEARN/TRANSMIT (ZONE 1/ZONE 2)
selector to "TRANSMIT (ZONE 1/ZONE 2)" to
finish the erasing procedure.
LEARN TRANSMIT
ZONE 1 ZONE 2
For the Zone 1 operations
LEARN TRANSMIT
ZONE 1
DVD DVD MULTI PHONO CD
CDR
TAPE/MD
VCR 1 VCR 2
EXT 7.1CH
TV/DBS VIDEO FM/AM
LEARN
EXIT
and
LEARN TRANSMIT
ZONE 1 ZONE 2
For the Zone 2 operations
ZONE 2
80