Connecting The Power Cord; Putting Batteries In The Remote Control - JVC RX-DP15BC Instructions Manual

3. Connect the plug of the transmitter to the IR
OUT jack of the receiver and attach the
transmitter.
Target component(s)
At an angle of
approx. 60°
Signal-emitting angle of the transmitter
Horizontally: 60˚
30°
30°

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference.
Note:
The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
– When you unplug the power cord.
– When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord.
When unplugging the cord, always grasp the plug so as not to
damage the cord.
COMPU AV TEXT CTRL
IR
LINK-4 COMPU OUT
COMPU
OUT
(SYNCHRO) LINK- LINK +12V
IR 10mA MAX
IN
Vertically: 60˚
15°
45°

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries
first.
2
1
LR6(AM3)
/L40(15A)
1. On the back of the remote control, remove the
battery cover.
2. Insert the batteries.
• Make sure to match the polarity: (+) to (+) and (–) to (–).
3. Replace the cover.
If the remote control cannot transmit signals or operate the receiver
correctly, replace the batteries. Use two LR6(AM3)/L40(15A) type
(alkaline) dry-cell batteries.
Notes:
• If you aim the remote control directly at the remote sensor on the
receiver, you can operate the receiver at a distance of up to 7 m.
• When replacing the batteries, finish changing them without delay;
otherwise, the stored signals are all erased (see pages 74 to 80).
When using the remote control in the dark
Press LIGHT.
The buttons on the remote control are
backlighted while you are using the remote
control.
If you do not press any button for about 5 seconds, the backlight
will turn off.
CAUTIONS:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (+) and (–) to (–).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
3
LIGHT
18