Description Of Warning Lights; Description Of Multifunction Display - Husqvarna NUDA 900 MY12 Operating & Maintenance Instructions

Description of warning lights

"ABS" warning light (not used).
ABS
Turning indicator warning light (GREEN)
This flashes when the turning indicators have
been turned on or the "HAZARD" button has
been pressed.
High beam warning light (BLUE)
This lights up permanently when the high beam
is on.
High coolant temperature warning light (RED).
This lights up permanently when the coolant
reaches the alarm temperature;
Slow down until you come to a stop, let the
engine idle and wait for the temperature to
decrease (scale shown on display) and the
warning light to go out.
If the problem persists, check the coolant level
in the expansion tank. If the liquid level is cor-
rect, contact your HUSQVARNA dealer.
Neutral warning light (GREEN)
This lights up permanently when the motorcy-
cle is in neutral.
Engine diagnosis warning light (ORANGE)
This lights up permanently when the engine
ECU has diagnosed malfunctioning.
There are two types of fault:
- Critical fault: the engine switches off and
you must contact your HUSQVARNA dealer.
- Fault with emergency operating: the engine
operates with reduced performance to allow
you to reach the nearest HUSQVARNA dealer
to have the fault checked.
"HAZARD" warning light (RED)
This flashes together with the warning light
and the turning indicators when switch
has been pressed.
Fuel reserve warning light (ORANGE)
This comes on when there are approximately 3
litres of fuel left in the tank.
You need to refuel.
Note *:
the fuel light normally switch off a few time after
the fuel refilling operation.

Description of multifunction display

3
4
1 2
8
SPECIFICATIONS - OPERATION - MAINTENANCE
1. "ICE" indicator:
This appears when the external temperature is
lower than 3°C or 37.4°F
2. "SERVICE" indicator:
This indicates that it is time for a service.
Contact your HUSQVARNA dealer to have sched-
uled maintenance work carried out.
3. "MAP II" indicator:
This appears when "RAIN" mapping is selected
4. km/h or mp/h odometer scale indicator (see
"setting units of measurement")
5. Speed indicator.
6. Display parameters:
This field is used to individually set the param-
eters below that will be displayed in (7).
ODO = Odometer / Total mileage
TRIP = Odometer / Partial mileage
(to set the functions, see "Setting parameters")
TEMP = Air temperature (AIR BOX) / Coolant
temperature
CON = Actual fuel consumption / Average con-
sumption.
CLOCK = Clock ( see "Clock adjustment").
7. This displays the parameter set in (6).
8. This lights up in sequence from left to right as the
coolant temperature increases.
5
6
7
EN - 13