Basic Connection - EverFocus ENVR8304D User Manual

2.3 Basic Connection

The instructions below describe the basic connection for ENVR8304D-8CH and ENVR8304E-8CH.
ENVR8304D:
EVNR8304D-8CH
1
NVR Smart Switch
Power Supply
1. Using the supplied Power Cord, connect one end to the 100-240 VAC~ port on the NVR and
the other end to the 100-240 VAC~ power outlet.
2. To view videos, connect a monitor to the HDMI or VGA port using the HDMI or VGA cable
supplied by the monitor manufacturer.
3. To manage the NVR over network, use a standard RJ-45 CAT5 10/100Mb Ethernet cable to
connect the WLAN port of the NVR to the network. Please refer to 2.5 Connecting the NVR
to the Network.
4. Connect the LAN port of the NVR to the Uplink port of a PoE device using a standard RJ-45
CAT5 10/100Mb Ethernet cable. Please see 2.3.1 Camera Connection for more details.
5. Connect the IP cameras to the 1~8 camera ports at the rear of the PoE switch using
Ethernet cables without separate power sources. Please see 2.3.1 Camera Connection for
more details.
6. Optionally connect a mouse or a keyboard (EKB200) to the NVR to control the system. You
can also control the system using the supplied IR Remote Controller.
7. Connect a microphone to the Audio-in RCA socket of the NVR. Note that the microphone
with a (built-in) amplifier and external power supply is required.
8. To listen to audio of video source, connect a speaker to the Audio-out RCA socket. Note
that the speaker with a (built-in) amplifier and external power is required.
Web Remote
Main Monitor Main Monitor
(HDMI) 2 (VGA)
5
IP Cameras 1 ~ 8
Figure 2-7
14
ENVR8304D-8CH / ENVR8304E-8CH
PowerVideo Plus
Client (CMS)
6
4
Mouse &
EKB200 Keyboard
Line Level
7
Audio In
8
Line Level
Audio Out