2.
Installation
2.1 Hard Disk Drive Installation
1. Make sure the NVR is power-off.
2. Unscrew the ten housing screws on the NVR, and open the housing.
3. Screw two HDD brackets on both sides of the HDDs using the Sliver Screws.
4. Use the SATA Cable, and connect one end to the SATA port on the small PCB inside the
NVR, and the other end to the SATA port on the HDD.
Figure 2-3
Figure 2-1
HDD Bracket
Figure 2-2
ENVR8304D-8CH / ENVR8304E-8CH
Silver Screw
10
Chapter
2