Table of Contents
Advertisement
Switcher Setup/Configuration
The flowchart below provides an overview of the Switcher Setup/Configuration
submenu and the options for each setting.
Extron
System 7SC
MENU
SWITCHER SETUP/
NEXT
CONFIGURATION
If you press the Menu button while a submenu is active, the next main menu
will become active. For example, the menu will change from the Switcher
Setup/Configuration menu or submenus to the Audio/Video Adjustments
main menu.
To return to the default screens, let the System 7SC time-out for 8 seconds, or
press the Menu button until the Exit? menu appears, then press the Next button.
Scaler Rate
NEXT
1280X1024, 60 Hz
Sync formats
Scaler output rates
• RGBHV (default)
• See the table on the next page for
• RGBS
available combinations of resolutions
• RGsB
and refresh rates.
Default: 640x480, 60 Hz
NOTE
Lock = Accu-RATE Frame Lock™
RGB Delay
Scaler Blue Out?
NEXT
1.5 Sec.
Delay time (in seconds)
Display blue & sync only
• 0.0 (default) up to
• No (default)
• 5.0
• Yes
in 0.5 sec. increments
Add Slave
NEXT
No Slave Swr
Add a slave switcher on input 1
Autoselect the input signal
• No Slave Swr (default)
format for the front panel input
...or select a slave switcher input quantity:
• No
• 8 Input Slave
• Yes (default)
• 10 Input Slave
RGB input has priority over
• 6 Input Slave
S-video & composite video if all
• 4 Input Slave
formats are active.
Room2 Relay Cnfg
NEXT
1.375 Sec
Configure the Room 2 relay
• Toggle On/Off (default) – Latching mode. The relay
remains open or closed until the button is pressed again.
• X.XXX Sec – Momentary mode. The relay is open or
closed for a set time, adjustable from 0.250 seconds to
2.000 seconds in 0.125 second increments.
System 7SC • Operation and Configuration
Scaler Sync
Scaler Polarity
NEXT
RGsB
H+/V+
Polarity combinations
• H-/V- (default)
• H-/V+
Edge Smoothing?
NEXT
(No)
Yes
No
(Yes)
Smooth edges
• No
• Yes (default)
Autoselect # 07
Room1 Relay Cnfg
NEXT
No
(Yes)
Toggle On/Off
Configure the Room 1 relay
• Toggle On/Off (default) – Latching
mode. The relay remains open or
closed until the button is pressed again.
• X.XXX Sec – Momentary mode. The
relay is open or closed for a set time,
adjustable from 0.250 seconds to 2.000
seconds in 0.125 second increments.
2:2 Pulldown
Input#01 : Off
Turn 2:2 Pulldown On/Off (per input)
• On – Select this to activate 2:2 film
detection for the selected input to maximize
image detail and sharpness for for PAL
source material that originated from film.
• Off (default) – 2:2 detection is off.
NEXT
• H+/V-
• H+/V+
NEXT
NEXT
NEXT
3-9
Advertisement
Table of Contents
