Calibrating The Pedals - Korg Stage Vintage SV-1 User Manual

30 – Advanced settings | Calibrating the pedals
C
ALIBRATING THE PEDALS
You can calibrate the pedals connected to the DAMPER, PEDAL 1 and PEDAL 2 con-
nectors in the back panel. By calibrating a pedal, you let the SV-1 understand its polar-
ity and the full range of values sent.
Connect all pedals to be calibrated to the SV-1. Remember that DAMPER expects
1.
the included Korg DS-2H damper pedal, PEDAL 1 expect a footswitch-type pedal,
and PEDAL 2 can be used to connect either a footswitch or expression-type pedal.
Set any expression-type pedal to its lowest setting.
2.
Turn the SV-1 off.
3.
Keep the AUTO/PEDAL button pressed, and turn the SV-1 on.
4.
When the AUTO/PEDAL LED starts to flash, release the button.
5.
If you do nothing in the next few seconds, the AUTO/PEDAL LED will turn off,
and the SV-1 will complete the start-up sequence.
While the AUTO/PEDAL LED is flashing, press the button again. SV-1 enters cali-
6.
bration mode.
Now calibrate PEDAL 1 (a footswitch). Completely depress the pedal, then release
7.
it. When you have finished calibrating the pedal connected to the PEDAL 1 jack,
FAVORITE button #1 will turn on.
Then, calibrate PEDAL 2. The procedure is different, depending on the use of a
8.
footswitch or an expression pedal:
• If you connected a footswitch, completely depress it, then release it.
• If you connected an expression pedal, push it all the way forward to its maximum
position, then return the pedal to its minimum or lowest position.
When you have finished calibrating the pedal connected to the PEDAL 2 jack,
FAVORITE button #2 will turn on.
Finally calibrate the DAMPER pedal. Completely depress the pedal, then release it.
9.
When you have finished calibrating the pedal connected to the DAMPER jack,
FAVORITE button #3 will turn on.
When finished calibrating:
10.
• If you calibrated all three pedals connected, SV-1 automatically exits calibration
mode and continue the start-up sequence.
• If you calibrated only one or two pedals, press the AUTO/PEDAL button again to
exit calibration mode and continue the start-up sequence.