Control Function Descriptions - Conair 150 User Manual

C o n t r o l F u n c t i o n D e s c r i p t i o n s
S c r e e n
SCREEN 1
CONAIR D100
CV2.21.00 DV2.21.00
SCREEN 2
MONDAY
07/22/03 07:59 AM
SCREEN 3 (Default Screen)
PROCESS TEMPERATURE
ACT 325°F SET 325°F
F u n c t i o n
Once power is turned on, this screen is
displayed for 3 seconds. It shows
CONAIR and the dryer type on the first
line, and the control program version and
display program version on the second
line.
Once power is turned on and screen 1 is
displayed for 3 seconds, this screen is dis-
played for another 3 seconds. It shows the
day of the week on the first line and the
date and time on the second line. If this
information is not correct, it can be
changed under the SETUP, DISP, DATE
TIME screen 73.
This is the DEFAULT screen. It shows
the process air temperature setpoint and
actual temperature measured at the inlet to
the drying hopper. The setpoint can be
changed by pressing the Select Category
button under the Setpoint Value. Once the
button is pressed, the setpoint will begin
to flash. The numeric keys can be used to
enter a new setpoint or the (+) or (-)
Increment / Decrement buttons can be
used to change the setpoint. Holding the
(+) or (-) buttons in will allow the number
to ramp up faster the longer the button is
held. The "ENTER" key must be
pressed to accept the new number. The
temperature setpoint range can be changed
under the
✐
NOTE: The supervisory pass-
word is required to change
certain parameters. More
detail about the password
can be on Page 4-39 and
under screen 85 on page
4-32.
When supplied for
central drying appli-
cations, this function
is not available.
(continued)
O p e r a t i o n l 4 - 1 1