Control Function Descriptions; C O N T R O L F U N C T I O N D E S C R I P T I O N S - Conair 200 User Manual

C o n t r o l F u n c t i o n D e s c r i p t i o n s

S c r e e n
SCREEN 1
up
Pr
SCREEN 2
150
CP
SCREEN 3
C 5.01
v2.0
SCREEN 4
d 5.02
v2.0
SCREEN 5 (Default Screen)
250
1
250
SCREEN 5 (Default Screen)
DRY
1
CNT
SCREEN 6
350
2
350
F u n c t i o n
Once power is turned on, this screen is
displayed for 5 seconds while the control
goes through self-checking.
Once power is turned on and screen 1 is
displayed for 5 seconds, this screen is
displayed for another 3 seconds. It shows
the dryer model number for which the
control is configured.
After the model number is displayed, this
screen flashes for 1 second and displays
the control board software version.
After the control versions is shown, the
screen flashes again for 1 second and dis-
plays the display board software version.
This is the DEFAULT screen. It shows the
process air temperature setpoint and actual
temperature measured at the inlet to the
drying hopper. The (+) or (-) buttons can be
used to change the setpoint. Holding the
(+) or (-) buttons in will allow the number
to ramp up faster the longer the button is
held. The display will return to the default
screen from anyplace in the menu structure
if nothing is done after 10 minutes.
Indicates configuration as a central dryer.
Shows the regeneration air setpoint and
actual temperature. The setpoint can not be
changed from this screen; it is shown only
as a reference.
When supplied for
central drying appli-
cations, this function
is not available.
O p e r a t i o n l 4 - 5