Mounting A Loader On The Hopper; Testing The Installation - Conair 150 User Manual

When configured
as a central dryer,
the drying temper-
ature can not be
set since there is
no process heater
in the system.
3 - 1 4 l I n s t a l l a t i o n
M o u n t i n g a L o a d e r o n t h e H o p p e r
If you have a Conair loader or vacuum receiver, you can
use the flange and mounting clips provided on the top of
the hopper. Refer to the manuals that came with your
receiver or loader for detailed installation instructions.
Te s t i n g t h e I n s t a l l a t i o n
You have completed the installation. Now it's time to make sure everything works.
1
Make sure there is no material in the hopper. If you
have mounted a loader or vacuum receiver on the hop-
per, disconnect the material inlet hose at the source or
turn the loader off.
2
Turn on the main power to the dryer. Make sure the
dryer's disconnect dial is in the ON position. This pow-
ers up the control and the display lights will illuminate.
3
Set the drying temperatures. Press temperature select
with the select category button, and then press the
Setpoint Adjust (+) or (-) buttons or enter the low setpoint temperature (150ºF
{66ºC}) on the numeric keypad and press enter.
Select Category Buttons Setpoint adjustment Buttons
(continued)