Taking Pictures Using Burst Mode - Panasonic Lumix DMC-CM1 Operating Instructions Manual

4. Camera

Taking Pictures using Burst Mode

Applicable modes:
Pictures are taken continuously while the shutter button is pressed.
≥ A maximum of 23 pictures is taken upon pressing the shutter button once when the burst speed is set to [SH].
≥ Pictures taken with a burst speed will be recorded as a single burst group.
1
From the Recording screen > [
(P91)
2
Select the burst speed.
Burst speed
(pictures/second)
Live View during Burst Mode
¢1
¢1 Number of recordable pictures
¢2 The electronic shutter will operate.
¢3 Depending on the recording conditions, the number of frames in a burst may be reduced. (For example,
when you set [i.Resolution] of the recording menu, the number of frames in a burst may be reduced)
¢4 Pictures can be taken until the capacity of built-in memory or microSD cards becomes full, however the
burst speed will become slower halfway. The exact timing of this depends on the aspect ratio, the picture
size, the setting for the quality and the type of microSD card used.
≥ The Burst speed may become slower depending on the following settings.
– [Picture Size] (P104)/[Quality] (P105)/[Sensitivity] (P87)/[Focus Mode] (P106,
≥ Refer to P105 for information about RAW files.
3
Focus on the subject and take a picture.
≥ Hold down the shutter button fully to activate the Burst Mode.
With RAW files ¢3
Without RAW files
] > [Rec] > [Drive Mode] > [Burst].
¢2
[SH]
[H]
(Super high
(High speed)
speed)
50 10
None None
—
Depends on the capacity of the microSD card
23
97
[M]
(Middle speed) (Low speed)
5
Available Available
108)
MP4 3:2
A A
L
30 p
0500 0500 0500
[L]
2
¢4