Specifications - JVC AX-V5BK Instructions Manual

Specifications

Amplifier
Output Power
Total Harmonic Distortion
(8 ohms, 1 kHz)
Frequency Response (8 ohms)
Audio Input Sensitivity/
Impedance (1 kHz)
Audio Output Level
Signal-to-Noise Ratio
('66 IHF/DIN)
RIAA Phono Equalization
Loudness
(Volume Control at –40 dB)
Video Input Sensitivity/
Impedance
Video Output Level
Synchronization
Signal-to-Noise Ratio
General
Power Requirements
Power Consumption
Dimensions (W x H x D)
Mass
At Stereo Operation
Front Channels
At Surround Operation
Front Channels
Center Channel
Rear Channels
PHONO
TUNER, CD, TAPE, VCR, VIDEO
PHONO (MM)
TUNER, CD, TAPE, VCR, VIDEO
TAPE, VCR
PHONO
TUNER, CD, TAPE, VCR, VIDEO
VCR, VIDEO
VCR, MONITOR OUT
Design & specifications are subject to change without notice
50 watts per channel, min. RMS, driven into 4 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
30 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
30 watts per channel, min. RMS, driven into 8 ohms, 40 Hz to 20
kHz with no more than 0.8% total harmonic distortion.
40 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.8% total harmonic distortion.
40 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more
than 0.8% total harmonic distortion.
40 watts per channel, min. RMS, driven into 8 ohms at 1kHz, with
no more than 0.8% total harmonic distortion.
0.8 %* at 30 watts output
(* Measured by JVC Audio Analysis System)
20 Hz to 20 kHz (±1 dB)
20 Hz to 20 kHz (±1 dB)
2.5 mV/47 k ohms
200 mV/47 k ohms
200 mV
70 dB/66 dB
87 dB/67 dB
±0.5 dB (20 Hz to 20 kHz)
+5 ± 2 dB at 100 Hz
1 Vp-p/75 ohms
1 Vp-p (at 1 Vp-p input)
negative
45 dB
AC 230V , 50 Hz
240 watts
5 watts (in standby mode)
435 x 146 x 403 mm
3 3 7
(17 / x 5 / x 15 / inches)
16 4 8
8.0 kg (17.7 lbs)
Page 28