Troubleshooting - JVC AX-V5BK Instructions Manual

Troubleshooting

Page 27
Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact
your JVC service center.
PROBLEM POSSIBLE CAUSE
The display does not light up The power cord is not plugged in
or the
pressed to set in the —OFF position
No sound from speakers Speaker signal cables are not
connected
The SPEAKERS 1 and 2 are not
set correctly
An incorrect source is selected
Sound from one speaker only Speaker signal cables are not
connected properly
The balance is set to one extreme
Howling during record Your turntable is too close to
playing speakers
Remote control does not There is an obstruction in front of
work the remote sensor on the
amplifier
Batteries are weak
SOLUTION
Plug the power cord into an AC outlet
POWER switch is
and press
_ON position
Check speaker wiring and
reconnect if necessary
Press SPEAKERS 1 and 2 correctly
Select the correct source
Check speaker wiring and reconnect if
necessary
Adjust the balance properly (see page
12)
Move speakers away from the turntable
Remove the obstruction
Replace batteries
POWER to set it in the