Connecting The Power Cord; Putting Batteries In The Remote Control - JVC AX-V5BK Instructions Manual

Connecting the Power Cord

POWER
_ON —OFF

Putting Batteries in the Remote Control

Before plugging the amplifier into an AC outlet, make sure that all connections have been made.
1. Plug the power cord into an AC outlet.
POWER to set it in the _ _ _ _ _ ON position.
2. Press
The STANDBY lamp lights up. A small amount of power is always consumed.
To shut off the power completely:
POWER to set it in the —OFF position.
Press
Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may
cause noise or screen interference.
The difference between the
• The POWER switch is the mains supply switch, allowing the amplifier to connect to the mains supply.
To shut off the power completely, press the
• The STANDBY/ON button is a functional on/off (standby) switch, and does not disconnect the
amplifier from the mains supply. A small amount of power is consumed even in standby mode for the
amplifier to accept signals from the remote control.
Notes:
The preset settings such as sound adjustment may be erased in the following cases:
POWER to set it in the — OFF position.
• When you press
• When you unplug the power cord.
• When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the amplifier. When unplugging the amplifier, always
grasp the plug itself so as not to damage the cord.
Before using the remote control, put the two supplied batteries in first. When using the remote control, aim
the remote control directly at the remote sensor on the amplifier.
1. On the back of the remote control, press down on the battery cover and slide it out.
2. Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (–) to (–).
3. Slide the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P (SUM-3)/
AA (15F) type dry-cell batteries.
CAUTIONS:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity indicated: (+) to (+) and (–)
to (–).
• Use the correct type of batteries. Batteries that look similar may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
POWER switch and the STANDBY/ON
POWER switch to set it in the —OFF position.
R6P (SUM-3)/AA (15F)
button
Page 8