Dvi Setting - Pioneer PDP-507CMX Technical Manual

[Applicable only when a PDA-5003/PDA-5004 is installed]

10) DVI Setting

Choose the component type (either [PC] or [VIDEO]) that is connected to INPUT2.
Settable condition: INPUT2
Factory setting: PLUG/PLAY: PC
BLACK LEVEL: LOW
1 Select 'SETUP'.
2 Place the cursor on 'DVI SET UP' then press the [SET]
button.
3 Place the cursor over 'PLUG/PLAY' and press the [2/3]
button to change the setting.
Each time a [2/3] button is pressed, the setting changes
as shown below.
3 PC
3 VIDEO* 2
* Applicable only when the video card is installed.
4 Place the cursor over 'BLACK LEVEL' then press the [2/3]
button to change the setting.
Each time the [2/3] button is pressed, the setting
changes as shown below.
3
LOW (0 to 255)
3 HIGH (16 to 235) 2
Note
When 'PLUG/PLAY' is set to 'VIDEO' then 'BLACK LEVEL' is set to 'HIGH'. However, there are devices that can
adjust BLACK LEVEL so confirm the setting on the device.
2
2
Screen 2
M E N U
P I C T U R E S C R E E N
P O W E R M G T.
S I G N A L F O R M AT
D V I S E T U P
SET
ENTER
Screen 3
DV I S E T U P
P L U G / P L AY
B L AC K L E V E L
SET
SET
Screen 4
DV I S E T U P
P L U G / P L AY
B L AC K L E V E L
SET SET
Menu Mode
I N P U T 1
S E T U P O P T I O N
: O F F
MENU
EXIT
: P C
: L OW
MENU
EXIT
: P C
: L OW
MENU EXIT
201