Signal Format Setting - Pioneer PDP-507CMX Technical Manual

[Applicable only when a PDA-5003/PDA-5004 is installed]

9) Signal Format Setting

This display automatically identifies PC signals and video signals such as from a DVD player by the frequency of the
input signal. The panel is equipped with a function for identifying the resolution of a PC signal.
Factory setting: AUTO
1 Select 'SETUP'.
2 Place the cursor over 'SIGNAL FORMAT' then press the
[SET] button.
3 Press the [2/3] buttons to change the setting.
Each time a [2/3] button is pressed, the signal format
changes as shown below.
3 AUTO 2
3 Others 2
• AUTO ........ It is distinguished as in "5.1.3 List of
Input Correspondence Signals 1) Input
correspondence signals personal
computer signals" (pg. 146 to 151)
• Others ....... Selectable resolutions are displayed
Note
The display method and selectable screen size differs for each setting. In order to obtain a proper reproduction
method and screen size, check the signal format setting when the signal is input. Change the setting as necessary.
Screen 2
M E N U
P I C T U R E S C R E E N
C O L O R T E M P.
AU TO P OW E R O F F
D N R
M P E G N R
C T I
P U R E C I N E M A
C O L O R D E C O D I N G
C O L O R S Y S T E M
S I G N A L F O R M AT
SET ENTER
Screen 3
S I G N A L F O R M AT
A U T O
:
SET SET
Menu Mode
I N P U T 1
S E T U P O P T I O N
: M I D D L E
: D I S A B L E
: M I D D L E
: L OW
: O N
: O F F
: R G B
: AU TO
MENU EXIT
MENU EXIT
199