Mirror Mode Setting - Pioneer PDP-507CMX Technical Manual

22) MIRROR MODE Setting

This function reverses the image displayed on the screen in various ways.
For normal reproduction:
For left-right reversed reproduction: Set to 'MIRROR MODE: X'
For up-down reversed reproduction: Set to 'MIRROR MODE: Y'
For up-down, left-right reproduction: Set to 'MIRROR MODE: XY'
Normal operating state
[MIRROR MODE: OFF]
Up-down, left-right reversal
[MIRROR MODE: XY]
The 'MIRROR MODE: XY' setting is useful when the panel is hung upside down from the ceiling. With the display
suspended from the PDK-5012 mount, run the bundled cables up toward the ceiling.
Note
• To reverse an up-down setting, set 'MIRROR MODE' to 'XY' or 'Y'.
• When using the PDK-5012 ceiling mount, pay attention to the operating temperature conditions (Refer to section
4.8, "Ceiling Mount Unit: PDK-5012" (pg. 116)).
Factory setting: OFF
1 Enter the integrator mode.
(Refer to section 5.4.1, "About the Integrator Mode" (pg. 214).)
2 Select 'OPTION'.
3 Place the cursor on 'MIRROR MODE' then press the [SET]
button to change the setting.
Set to 'MIRROR MODE: OFF'
Left-right reversal
[MIRROR MODE: X]
Up-down reversal
[MIRROR MODE: Y]
Screen 3
I N T E G R AT O R
P I C T U R E S C R E E N
P W R . O N M O D E
S E A M L E S S S W
M I R R O R M O D E
M U L T I S C R E E N S E T
R E P E AT T I M E R
F U N C T I O N R E S E T
CHANGE
SET
Integrator Mode
I N P U T 1
S E T U P O P T I O N
:
X
EXIT
MENU
247