Factory/Network Resets; Regulatory/Safety Information; Warranty; About This Document - Control 4 HC-250 Installation Manual

3
While pressing and holding the Factory Restore
button, power on the HC-250.
4 Hold the button until the WiFi Status LED blinks
Orange. This should take five (5) to seven (7)
seconds. The Status LED will blink Orange while
the restore is running.
Factory Resets
• Press the Factory Restore button, but do not hold
it down. The Controller will reset.
Identification Button (Network Reset)
To reset the HC-250 network settings to the default,
perform the following steps:
1
Disconnect power to the HC-250.
2 While pressing and holding the ID button on the
back of the HC-250, power on the HC-250.
3 Hold the ID button until the Data, Link and Power
LEDs are solid Blue, then immediately release the
button.
4 If during the boot sequence the Status LED stays
Orange, press and hold the Identification button
until the LED blinks Blue, and then release it.

Regulatory/Safety Information

To review regulatory information for your particular
Control4 products, see the information located on
the Control4 website at: http://www.control4.com/
regulatory/.

Warranty

Go to http://www.control4.com/warranty for details.

About This Document

Part number: 200-00240, Rev. D 08/17/2012
6
©2012 Control4. All rights reserved. Control4, the Control4 logo, the Control4 iQ logo and the Control4 certified logo are registered trademarks or trademarks of Control4 Corporation in
the United States and/or other countries. All other names and brands may be claimed as the property of their respective owners.
control4.com |
™