Handset Replacement With Ims2 In Dect Or Ip-Dect System (Release 3.0.X Or Lower); Replacement Of The Handset With The Pdm Windows Version - ASCOM d41 Configuration Manual

Configuration Manual
Ascom d41 DECT Handset
2 Insert the handset into a desktop charger or rack charger connected to IMS2 (not
needed if an over the air connection is used). Navigate to the Numbers tab in IMS2
Device Manager.
The new handset now has the same User ID as the old handset. It will automatically
be synchronized and data and parameter settings from the old handset will be
transferred to the new handset.
The synchronization will take a while if the Contacts in the original handset contains
a large number of contacts.
4.7.3 Handset Replacement with IMS2 in DECT or IP-DECT System (release 3.0.x or
lower)
1 Make a note of the IPDI of the new handset. It is found by pressing *#06# on the
handset.
2 Insert the new handset into a desktop charger or rack charger connected to the IMS2
and navigate to the Numbers tab in the Device Manager in IMS2.
3 In the list, right-click the old handset and select "Associate with device...". Select the
device with an IPDI that matches the new handset from the list that opens.
The new handset is automatically synchronized and all data and parameter settings
will be transferred to the new handset.
The synchronization will take a while if the Contacts in the original handset contains
a large number of contacts.
Subscribe the new handset. The subscription procedure is described in User Manual, Ascom
d41 DECT Handset, TD 92582GB. During the subscription procedure, the handset's User ID
will automatically be set to be the same as the extension number.
4.8

Replacement of the handset with the PDM Windows Version

To see which data that is replaced during this process, see
replacement transfer
Both the old handset and the new handset must be of the same device type (d41). The
same extension number is assigned to the new handset.
The new handset should not be subscribed towards the PBX yet.
1 Perform a factory reset, see
handset has been previously used.
2 Make sure that the old handset is saved in the PDM by starting PDM and navigating
to the Numbers tab. There shall be a tick in the "Saved" column for the old
handset.
If the handset is not saved, insert it into a desktop charger or rack charger connected to
the PDM and perform a save.
Note: If it would be impossible to save the old handset settings, stop this replacement
procedure. Instead register the new handset and follow the instructions for installing a
handset, see
The following steps are described in two different scenarios, check which one suits the
best before proceeding.
21 December 2010/ Ver. E
on page 12.
4.5 Perform a Factory reset
3.2 Installation of a new Handset
4.7.1 Data included in a
on page 11, if the new
on page 5.
TD 92641GB
13