Operation; Switching On - Miele KM 2012 Operating Instructions Manual

Operation

Switching on

16
The control is used to ignite the burner and to regulate the
strength of the flame.
ßThe gas supply is turned off
& Strong flame
/ Weak flame
The burners can only be switched on by pressing in the
appropriate control and turning it anti-clockwise, and
switched off by turning the control clockwise.
The following will cause damage to the appliance:
- Switching on the burner without pressing the control
down,
- Switching the burner on by turning the control
clockwise,
- Switching the burner off by turning the control anti-
clockwise.
The manufacturer will not accept liability for any damage
resulting from incorrect operation.
,
Do not leave the appliance unattended whilst it is
being used.
^ The control for the burner required must be pressed in and
turned anti-clockwise to the large flame symbol to switch
on.
A spark is automatically produced on all burners when a
control knob is activated. This is completely normal and
does not indicate a fault with the appliance.
^ When the flame ignites, keep the control pressed in for
8-10 seconds, and then let it go.
^ If the flame goes out turn the control to "ß" and wait for at
least 1 minute before trying to ignite it again. If necessary
keep the control pressed in for longer.
^ If the burner does not ignite after a second attempt turn the
control back to "ß" and go to the "Problem solving guide" for
advice.