Indication Of Remote And Local Events On The Lcd; Acoustic Indicators; Summary Of Conditions - Ziton ZP2-F Series Operation Manual

Indication of remote and local events on the LCD

The local control panel ID is always displayed on the LCD (see Figure 2 on
page 7).
If your control panel forms part of a fire network, the event notification includes
the panel ID reporting the event as follows:
• If the panel ID matches the local ID, then the event relates to the local control
panel.
• If the panel ID does not match the local ID, then the event is reported by the
remote control panel with the panel ID indicated.
Note: Repeater panels are installed only in fire networks and by default have a
network board installed. Fire alarm control panels must have a network board
installed to connect to a fire network.

Acoustic indicators

The control panel uses the following acoustic indicators to highlight system
events.
Indication
The buzzer sounds continuously
The buzzer sounds intermittently (long tone) [1]
The buzzer sounds intermittently (short tone) [1] Indicates a condition
[1] A long tone is 50% ON and 50% OFF. A short tone is 25% ON and 75% OFF.

Summary of conditions

System events logged as conditions are shown below.
Table 4: System events logged as conditions
Condition
Tests
Disablements
Sounder, fire routing, and fire
protection delays
Loop device not configured
Input activation
Output group activation
New node in the fire network
ZP2-F Series Fire Alarm Control Panel Operation Manual
Description
Indicates a fire alarm or a system fault
Indicates all other faults
Description
A control panel feature or device is being tested
A control panel feature or device is disabled
A sounder, fire routing, or fire protection delay is enabled or
disabled
A loop device is detected that is not configured
An input is activated (subject to configuration)
An output group is activated
A control panel has been added to the fire network
9