Victory Motorcycles Classic Cruiser 2002 Service Manual page 27

MAINTENANCE
TUNE UP SPECIFICATIONS
ITEM
Lubrication Oil Pressure @ 3000 rpm
Cooling Oil Pressure @ 3000 rpm
Drive Belt Deflection
Throttle Grip Freeplay
Idle Speed
Fast Idle Speed
Fast Idle Lever Freeplay
Clutch Lever Freeplay
Spark Plug Type / Gap
Start the engine and warm it up for several minutes. While warming up, check for oil leaks. If any leaks are found,
stop the engine immediately and determine the source of the problem before starting the engine again.
NOTE: After the engine is started, the oil indicator light should go off. If the indicator light flickers or remains on,
immediately stop the engine and diagnose the problem before continuing.
Drain Plug
(Inspect / replace O-ring or sealing washer)
Oil Filter
Oil Type
Oil and Filter Change
Use Victory 20W40 engine oil for all temperatures. If Victory oil is not available, use 20W40 SG or equivalent.
Do not put chemical additives in the oil. Victory motorcycle oil has
been specially designed for this application. Additional additives are
not necessary and have not been approved by Victory Engineering.
2.6
All Except Touring Cruiser Models
8 mm (.315") With 10-12 lb Load @ Center Span
Touring Cruiser Models
9 mm (.354") With 10-12 lb Load @ Center Span
.25-.75mm (.010-.030")
2002-2003 NGK CR7EB / .8mm (.032")
2004 Touring Cruiser NGK CPR6EA-9 / .8mm (.032")
TIGHTENING TORQUE
2002 (22x1.5) - 38 Nm (28 ft. lbs. )
2003-2004 (12x1.5) - 27 Nm (20 ft. lbs. )
3/4 full turn after contacting the sealing surface
OIL TYPE / QUANTITY
Victory Semi-Synthetic 20W40 Engine Oil
SPECIFICATION
552 kPa (80 psi)
414 kPa (60 psi)
3-6mm (1/8-1/4")
950 RPM ± 50
2000 RPM ± 100
3-6mm (1/8-1/4")
( )
6.15 liters (6.5 quarts)