Christie LX700 Service Manual page 34

Optical Parts Disassembly
Note on LCD Panel/Prism Ass'y Mounting
After replacing or installing the LCD Panel/Prism ass'y, please make
sure to obtain the best focus in both TELE and WIDE zoom. If the
focus adjustment is required, please adjust the positioning of LCD
Panel/Prism Ass'y following to the procedure below.
Focus adjustment:
1 Loosen 4 screws A on the LCD Panel/Prism ass'y with 2.0 mm hex
driver.
2 Turn the projector on and project the image with WIDE zoom, and
adjust the FOCUS control to obtain the best focus.
3 Turn the ZOOM control to the TELE position.
4 Insert a flat screw driver into the slot B and move the LCD Panel/
Prism Ass'y backward or forward by turning the screwdriver left
or right to obtain the proper focus. Confirm the focus at TELE and
WIDE zoom.
5 Tighten 4 screws A to fix the LCD Panel/Prism ass'y.
LX700 Service Manual
B
Rev. 1 (11/08)
-32-
A
A
020-000120-01