Using Coating Materials In Sacks; Container Suction System; Placing Out Of Operation And Cleaning; Cleaning The Mortar Hose - WAGNER Plast Coat 25 Operating Manual

GB

placIng out of operatIon and cleanIng

using coating materials in sacks

• Pull sliding cover back about 15 cm.
• Place sack on the sliding cover in such a way that the top
faces the front end of the sliding cover.
• Cut sack open.
• Allow the coating material to flow into the receptacle.
• Move sack mangle forwards over the sack by turning the
crank handle until the guide rollers reach the stop pins.
• To ease pressing – move sack mangle to frame of sack man-
gle with your left hand.
• Strip remaining coating material from sack opening with a
spatula.
9.3

CONtAINeR SuCtION SySteM

• Turn off device at master switch.
• Pull out mains plug from the socket and ensure that it can-
not be plugged back in unintentionally.
• Unscrew the hexagon nuts (2) on the receptacle (1, Fig. 19),
remove washers.
• Remove receptacle.
• Attach container connection (3) to the base of the recepta-
cle. Mount disks and secure with hexagon nuts (2).
• Connect suction hose (5) to container connection (3). Al-
ternatively, connect connecting bridge (6) to the container
connection (3) and connect suction hose (5) to connecting
bridge.
• Fill suction hose with water and connect to the container.
• Turn on mortar spraying machine.
Note:
All connections must be sealed air tight so that a vacuum can
be produced.
Place a small amount of machine lubricant onto the rubber
seals of the connections in order to allow for the easy opening
and closing of the connectors.
40

2
6
2
10
PlACING Out OF OPeRAtION ANd
CleANING
do not spray the motor or control unit of
the mortar spraying machine with wa-
ter jet, high-pressure or steam cleaning
equipment. Water could penetrate the ma-
chine and cause a short-circuit.
10.1

CleANING tHe MORtAR HOSe

• Pump until receptacle is empty.
When operating using the container suction system, remove
suction hose from the container.
Important: do not let the mortar spray machine run
dry.
• Remove texture nozzle from spray lance and clean.
the mortar hose must be without pres-
sure. If necessary, turn changeover switch
briefly to
Note the pressure gauge ––> 0 bar.
Wear protective goggles.
Plast Coat 25 · 35
1
(backwards).
5
3