Table of Contents
Advertisement
Plast Coat 25 · 35
material delivery rate and air delivery rate.
fine texture
coarse texture
Higher material
delivery rate
We recommend that you test the required texture on a sample
surface.
To improve the „feathering effect" in order to allow easier over-
lap, choose an appropriate distance between the spray lance
and the object surface.
The spray margin should „feather out" to allow easier overlap-
ping.
Considerably less spray mist is produced if the spray lance is
always guided at 90° parallel to the spray surface.
Note:
Sharp-edged grains and pigments will increase wear on the
pump, hose, material ball valve and tip.
9
FIttING ACCeSSORIeS
9.1
COMPReSSOR
V 400 suction volume 360 l/min
• Attach compressor holder (item 1, fig. 17) and secure with
star grip (2).
• Place compressor onto holder. Slide retaining plate (3) over
the compressor base.
• Secure the compressor with star grips (4).
––> larger air delivery rate
––> low air delivery rate
––> higher air delivery rate
2
9.2
SACk MANGle
Safety note
technical data
Roller length: 465 mm
Roller diameter: 66 mm
Weight: 6.7 kg
Putting sack mangle into operation
• Connect crank handle (1, fig. 18) and secure with linch pin.
• Insert sack mangle and sliding cover (2, accessory).
• Screw out star grips (3) about 2 cm.
• Place sack mangle and crank handle (1) on the sliding cover
to the right from the front. Move guide rollers (4) over stop
pins on the underside of the sliding cover.
• Adjust pressure force of the roller (5). Turn the star grips (3)
to the right until they will go no further.
• Turn crank and move sack mangle to the rear as far as it will
go.
3
4
1
danger of crushing.
do not pace hands under the roller.
2
1
GB
fIttIng accessorIes
3
5
4
39
Advertisement
Table of Contents
