Safety Requirements - WAGNER Plast Coat 25 Operating Manual

GB

safety requIrements

1
SAFety ReQuIReMeNtS
All local safety regulations in force must be observed.
For safe operation of the mortar spraying machines, always
comply with the following specific instructions:
1. use of the mortar spraying machines
the mortar spraying machines PlastCoat 25 and 35
are designed only for the spraying of the materials
described on page 27. Any other use is not permit-
ted. the manufacturer cannot be held liable for any
damage resulting from this. In such cases, the risk
will be borne solely by the user.
Intended use also includes compliance with the Op-
erating manual and compliance with the inspection
and servicing conditions. Always keep the Operating
manual ready at hand at the machine location.
2. the mortar spraying machines PlastCoat 25 and 35
may only be operated with a pressure gauge. Only the
mortar hose prescribed by the manufacturer may be
used.
3. Only use identified mortar hoses with an operating
pressure of at least 40 bar.
4. Personnel safety
Always wear protective goggles, protective clothing and
gloves and, if necessary, skin barrier cream and breath-
ing equipment, to protect your eyes, skin and respiratory
system.
Never uncouple mortar hose while it is still under pressure.
Note pressure gauge!
Wear protective goggles!
Never aim spray lance at any person!
5. Breathing masks
Breathing masks must be provided for the operator to
protect against mineral dust.
6. Only connect to the mains supply using a special dis-
tributing point, e.g. using site distribution system with
fault current protection with INF ≤ 30 mA.
7. the master switch has an eMeRGeNCy OFF function.
28
danger of injury from the screw conveyor.
Only reach into the container with the mor-
tar spraying machine switched off.
Only switch on the mortar spraying machi-
ne with the safety grill inserted.
the safety grill must be inserted for all day
to day working and cleaning activities
8. Prevent the socket for the remote control on the control
unit from getting dirty.
Always leave the coupler plug of the remote control line
on the mortar hose screwed complete into the control
unit.
9. Cleaning and servicing
Never uncouple mortar hoses under pressure. Before un-
coupling, check pressure on the pressure gauge.
Turn off the mortar spraying machine for cleaning and
maintenance work. Pull out mains plug and ensure
that it cannot be plugged back in unintentionally.
Do not spray the motor or control unit of the mortar
spraying machine with water jet, high-pressure or steam
cleaning equipment. Water could penetrate the machine
and cause a short-circuit.
10. electrical equipment
Work on the machine's electrical equipment may be car-
ried out only by a qualified electrician. The electrical
equipment must be inspected regularly. Defects such as
loose connections or scorched cables must be remedied
immediately.
11. keep the labels on the mortar spraying machine clean
and legible.
12. Positioning on uneven ground
The front of the mortar spraying machine must point up-
wards to avoid that the machine slips away.

Plast Coat 25 · 35