Calibration Setup - Adam Equipment PGL SERIES Manual

1) Use the [Up] and [Down] keys to increase or decrease the value for setting.
Press [Enter] to accept the setting and advance to the next item in the menu
2) Press [Mode] to advance to setting of the next parameter or [Esc] to return to
normal weighing

12.5 CALIBRATION SETUP

This menu allows the user to set the calibration parameters.
Press [Enter] when "CAL SETUP" is displayed to select the calibration parameters
The options for each parameter can be scrolled through by using the [Up] or
[Down] key
ENABLE
CAL REPORT
TIME CAL
Press [Mode] to advance to setting of the next menu which is "PASSCODES" or
[Esc] to return to normal weighing.
NO =operator calibration is disabled
YES=operator calibration is enabled
On = Enabled. Prints out Calibration report after
successful calibration
OFF = Disabled
On = Enabled. Select time from 1 to 24 hours.
OFF = Disabled
32 | P a g e © Adam Equipment Company 2011