Rear-Wheel Stand - BMW K1300R Manual

Tighten adjusting screws 1.
8
118
If the motorcycle is on the
centre stand and is raised
z
too far, the centre stand will lift
clear of the ground and the mo-
torcycle could topple to one side.
When raising the motorcycle,
make sure that the centre stand
remains on the ground.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.

Rear-wheel stand

Installing rear-wheel
stand
Use basic stand with tool num-
ber (0 402 245) in combin-
ation with rear-axle adapter
(0 402 250).
Use screws 1 to set the rear-
wheel stand to the desired
height.
Remove retaining disc 2. To
do so, press release button 3.
Remove retaining disc 2. To
do so, press release button 3.
Make sure the ground is level
and firm and place the motor-
cycle on its side stand.
Push the rear wheel stand from
the left into the rear axle.
Push on retaining disc 2 from
the right, while holding the re-
lease button down.
Grip the rear grab handle of the
motorcycle with your left hand
and use your right to grip the
handle of the rear-wheel stand.