BMW K1300R Manual page 115

with BMW Motorrad Integral
ABS II OE
Remove screw 1 and remove
the ABS sensor from its bore.
OA
without centre stand
Place the motorcycle on an
auxiliary stand; BMW Motorrad
recommends the BMW Motor-
rad rear-wheel stand.
Installing rear-wheel stand
( 118).
OA
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Raise front of motorcycle until
the front wheel can turn freely.
BMW Motorrad recommends
the BMW Motorrad front-wheel
stand for lifting the motorcycle.
Installing front-wheel stand
( 117).
The left axle clamping
screw locates the threaded
bush in the front suspension.
If the threaded bush is not
correctly aligned the gap
between the ABS sensor ring
and the ABS sensor will not be
correct and this can cause the
ABS to malfunction or allow the
ABS sensor to be damaged.
In order to ensure that the
threaded bush remains correctly
aligned, do not slacken or
remove the left axle camping
screw.
Remove right-hand axle clamp-
ing screw 2.
Remove quick-release axle 3,
while supporting the wheel.
Lower the front wheel to the
ground between the front forks.
Roll the front wheel forward to
remove.
with BMW Motorrad Integral
OE
ABS II
Take care not to dam-
age the ABS sensor when
rolling out the front wheel.
Note the ABS sensor when
rolling out the front wheel.
Roll the front wheel forward to
remove.
8
111
z